مرحبا بكم في موقعنا الجديد..!!

Passive holder with tilt swivel

رقم الصنف : 530480

Fits unit both with and without handstrap.

Getac Z710 (EU Version)

Getac Z710 (US Version)

more...

الكمية

إنتهى من المخزن

الوصف

Fits unit both with and without handstrap.

معلومات فنية

With your Getac in a holder attached in your vehicle you will always have it within easy reach. Safe, neat and convenient! You can connect e.g. a charging cable to the device when it is in the holder.

  • The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the device into place in the holder, and to take it with you when leaving the vehicle.

  • التعليمات

    Please read all of the instructions and look at the pictures before attaching the holder.

  • 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
  • Technical Information Illustration
  • 2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.
  • Technical Information Illustration
  • 3. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. To remove the device from the holder: Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.
  • Technical Information Illustration
  • 4. The holder is in place.
  • Technical Information Illustration

    التوافق

    • Getac : Z710 (EU Version)
    • Getac : Z710 (US Version)

    السلة

    شركة ثابت، شركة قطرية متخصصة في توفير حلول تركيب المركبات المصممة بدقة. تأسست عام ٢٠٠٩، ونقدم ملحقات عالية الجودة ومتينة، تحظى بثقة عملائنا في جميع أنحاء دول مجلس التعاون الخليجي، سواءً للاستخدامات التجارية أو الشخصية.

    • بريد الكتروني: info@thabt.qa
    • هاتف: +974 4483 2731
    عنوان
    • رقم الوحدة - 16, رقم المبنى - 419, رقم شارع - 990
    • رقم منطقة - 52, الريان القديم الدوحة قطر
    • هاتف: +974 4465 2421
    • رقم الوحدة - 10, رقم المبنى - 191, رقم شارع - 750
    • رقم منطقة - 71, أم صلال محمد, الدوحة قطر
    • هاتف: +974 5015 2425

    الشروط و القوانين | سياسة الخصوصية | سياسة ملفات الارتباط